Flat and pointed Electrolytic Ground Rod for Lightning protection

Instruction of Use

1. Drilling

Dill the hole about 140mm×3500mm on the earth , or dig the channel about 300mmx3500x800mm and install the grounding rod . Multi grounding rods should be connected by the channel 350mmx600mm.

2. Install the ion grounding rod and connect lead wire;

Remove the seal tape of water absorbing hole and releasing hole (Must );

Put the electrode into assy hole;

Connect the lead wire with anti-corrosion bolt and welded with exothermic welding;

If grounding grid is needed with multi grounding electrodes , 95mm2 copper stranded wire or galvanized round wire or galvanized tape is recommended to connected with exothermic welding.

3. Fix bentonite and water and fill

Fix bentonite and water with the ratio 1:1;

Fill the bentonite and about 50mm higher than electrode , and stir with stick to exhaust the air;

Check the connect the refill the soil ,no stone ,stick or plastic piece left.

4. Test the resistance

Test the resistance 3 days later after installation , and retest one month later and six month later to observe the change.

Characteristics of Copper bonded earthing system:

1. The advanced automatic electroplating production lines and four dimensional continuous speed electroplating processes ensure the uniform coating and stable performance.
 
2.“Accelerate corrosion experiments” are carried by China authority department with different soil types, and the service life is proven more than 40 years.
 
3. The factory lab is equipped with advanced analytical instruments, e.g. atomic absorption spectrophotometer, UV-Vis spectrophotometer, conductivity meter, COD meter, PH meter etc. analyzed instruments. It also includes Metallurgical Microscopy, universal testing machine, Salt Spray test chamber, and thickness tester etc. These instruments can analyze and test dozens of technical parameters during the plating production process, which ensures the reliable electroplating process.